Mitsubishi — 7.3.2 Operation

AH500 Motion Control Module Manual Velocity V MAX V JOG V BIAS T A T D [Description] 2. Operation command  Bit 2=1: Positive JOG motion  Bit3=1: Negative JOG motion 7.3.2 Operation  When bit 2 in SR1030+100*N is ON, clockwise pulses are generated at the JOG speed set.  When bit 3 in SR1030+100*N is ON, counterclockwise pulses are generated at the JOG speed set.  After a JOG mode is activated, the AH500 series motion control module used will execute JOG motion. The speed of JOG motion can be modified when the JOG motion is executed. If the value in (SR1011+100*N, SR1010+100*N) is 0, the JOG motion of the axis specified will be stopped, and will needs to be started again.

If JOG motion is started when the value in (SR1011+100*N, SR1010+100*N) is 0, an error will occur. 7-16 (1+N)th axis HW LW - SR1030+100*N Special data register SR1030+100*N b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0 - - - The execution of the Ox motion subroutine set starts. A mode of inserting two-speed motion is activated. A mode of two-speed motion is activated. A mode of inserting single-speed motion is activated. A mode of single-speed motion is activated. - A mode of triggering the return to home is activated. A manual pulse generator is operated. A mode of variable motion is activated. The axis specified operates in JOG- mode. The axis specified operates in JOG+ mode.

- The motion of the axis specified is stopped by software.