Mitsubishi — 7.5.1 Related Special Data Registers

Chapter 7 Uniaxial Motion [Description] The value in (SR1045+100*N, SR1044+100*N) indicates the frequency of pulses generated by the manual pulse generator for the axis specified. It does not vary with the values in SR1042+100*N and SR1043+100*N. 2. Frequency of pulses generated by the manual pulse generator for the axis specified 3. Number of pulses generated by the manual pulse generator for the axis specified [Description]  The value in (SR1047+100*N, SR1046+100*N) indicates the number of pulses generated by the manual pulse generator for the axis specified.

If the pulses generated by the manual pulse generator for the axis specified are clockwise pulses, the value in (SR1047+100*N, SR1046+100*N) will increase. If the pulses generated by the manual pulse generator for the axis specified are counterclockwise pulses, the value in (SR1047+100*N, SR1046+100*N) will decrease.  The value in (SR1047+100*N, SR1046+100*N) does not vary with the values in SR1042+100*N and SR1043+100*N.  4. Response speed of the manual pulse generator for the axis specified [Description]  If the response speed set is high, the pulses output happen almost at the same time as the pulse input by the manual pulse generator used.

 If the response speed set is low, the pulses output follows the pulses input by the manual pulse generator used. 7-19 (1+N)th axis HW LW SR1045+100*N SR1044+100*N (1+N)th axis HW LW SR1047+100*N SR1046+100*N (1+N)th axis HW LW - SR1048+100*N Setting value Response speed ≧5 4 ms (Initial value) 4 32 ms 3 108 ms 2 256 ms 1 or 0 500 ms