AH500 Motion Control Module Manual 5. Operation command [Description] If users want to activate a manual pulse generator mode, they have to set bit 5 in SR1030+100*N to 1. 7.5.2 Operation If bit 5 in SR1030+100*N is set to 1, a manual pulse generator mode will be activated. The value in (SR1047+100*N, SR1046+100*N) indicates the number of pulses generated by the manual pulse generator for the axis specified. Servo drive B phase A phase Servo motor Frequency of input pulses X SR1042(SR1142,...) SR1043(SR1143,...) RP FP 7.6 Introduction of a Mode of Triggering the Return to Home = Frequency of output pulses 7.6.1 Related Special Data Registers 1.
Speed (V RT ) at which the axis specified returns home [Description] Users can set the speed at which the axis specified returns home. The value in (SR1013+100*N, SR1012+100*N) is in the range of 1 to 2,147,483,647. (The unit used is determined by bit 0 and bit 1 in SR1000+100*N.) The frequency of pulses generated by motion is in the range of 10 PPS to 1000K PPS. If the value in (SR1013+100*N, SR1012+100*N) is greater than 1000K, the frequency of pulses generated will be 1000K PPS.
If the value in (SR1013+100*N, SR1012+100*N) is less than 10, 7-20 (1+N)th axis HW LW - SR1030+100*N Special data register SR1030+100*N b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0 - - - The execution of the Ox motion subroutine set starts. A mode of inserting two-speed motion is activated. A mode of two-speed motion is activated. A mode of inserting single-speed motion is activated. A mode of single-speed motion is activated. - A mode of triggering the return to home is activated. A manual pulse generator is operated. A mode of variable motion is activated. The axis specified operates in JOG- mode. The axis specified operates in JOG+ mode.
- The motion of the axis specified is stopped by software. (1+N)th axis HW LW SR1013+100*N SR1012+100*N