Mitsubishi — 7.6.1 Related Special Data Registers

AH500 Motion Control Module Manual written into (SR1033+100*N, SR1032+100*N). 6. Mode of operation [Description]  Bit 2 in SR1031+100*N: Mode of sending a CLR signal  Bit 2=0: After the axis returns home, the CLR output will send a 130 millisecond signal to the servo drive, and the present position of the servo drive which is stored in a register in the servo drive will be cleared.  Bit 2=1: The CLR output functions as a general output. 7. Setting the parameters of the axis specified [Description] Motion of retuning home:  Bit 8 in SR1000+100*N: Direction in which the axis specified returns home  Bit 8=0:

The value indicating the present command position of an axis specified decreases, and the axis returns home in the negative direction.  Bit 8=1: The value indicating the present command position of an axis specified increases, and the axis returns home in the positive direction.  Bit 9 in SR1000+100*N: Mode of returning home  Bit 9=0: Normal mode After DOG’s signal is generated, the motor used will rotate for a specific number of PG0 pulses, then rotate for a specific number of supplementary pulses, and finally stop.  Bit 9=1:

Overwrite mode After DOG’s signal is generated, the motor used will rotate for a number of PG0 pulses or rotate for a number of supplementary pulses, and then stop.  Bit 10 in SR1000+100*N: Mode of triggering the return to home  Bit 10=0: The return to home is triggered by a transition in DOG’s signal from high to low.  Bit 10=1: The return to home is triggered by a transition in DOG’s signal from low to high. 7-22 (1+N)th axis HW LW - SR1031+100*N (1+N)th axis HW LW - SR1000+100*N