Chapter 7 Uniaxial Motion Velocity (PPS) Away from DOG's signal Close to DOG's signal V RT V CR V CR Direction in which the axis specified returns hom e Number of supplementary pulses Number of PG0 pulses DOG Bit [9:10] in SR1000+100*N is 10. The mode of returning home is an overwrite mode, and the return to home is triggered by a transition in DOG’s signal from high to low. Steps: (1) The motor used rotates at the speed V RT . (2) When DOG’s signal is generated, the speed of the motor begins to decrease to the speed V CR .
(3) After DOG’s signal goes from high to low, the motor will rotate for a specific number of PG0 pulses, or rotate for a specific number of supplementary pulses, and then stop. If the number of PG0 pulses or the number of supplementary pulses is not large, the speed of the motor used will decrease to the speed V CR after DOG’s signal is generated. After DOG’s signal goes from high to low, the motor will rotate for a specific number of PG0 pulses, or rotate for a specific number of supplementary pulses, and then stop whether the its speed is V CR .
If the number of PG0 pulses is 0, and the number of supplementary pulses is 0, the motor used will stop after DOG’s signal is generated and there is a transition in DOG’s signal from high to low. Velocity (PPS) Away from DOG's signal Close to DOG's signal V RT V CR V CR Direction in which the axis specified returns home Number of supplementary pulses Number of PG0 pulses DOG Bit [9:10] in SR1000+100*N is 11. The mode of returning home is an overwrite mode, 7-25