Mitsubishi — 7.7.2 Operation

Chapter 7 Uniaxial Motion 2. Speed at which the axis specified rotates (V (I)) [Description]  The value in (SR1025+100*N, SR1024+100*N) is in the range of 0 to +2,147,483,647. (The unit used is determined by bit 0 and bit 1 in SR1000+100*N.)  The frequency of pulses generated by motion is in the range of 10 PPS to 1000K PPS. If the value in (SR1025+100*N, SR1024+100*N) is greater than 1000K, the frequency of pulses generated will be 1000K PPS. If the value in (SR1025+100*N, SR1024+100*N) is less than 10, the frequency of pulses generated will be 10 PPS.  V MAX > V (I) > V BIAS  When an axis operates, users can modify its V (I).

If the value in (SR1025+100*N, SR1024+100*N) is 0, the motion of the axis specified will be stopped, and will need to be started again. 3. Operation command [Description]  If users want to activate a mode of single-speed motion, they have to set bit 8 in SR1030+100*N to 1. 7.7.2 Operation  After bit 8 in SR1030+100*N is set to 1, a mode of single-speed motion will be activated. The target position of the single-speed motion and the speed of the single-speed motion depend on the P (I) and the V (I) which are set by users.  If relative single-speed motion is activated, the sign bit of the P (I) set by users will determine the direction of the relative single-speed motion.

After relative single-speed motion is activated, the speed of the relative single-speed motion will increase from the V BIAS set to the V (I) set. The speed of the relative single-speed motion will not decrease from the V (I) set to the V BIAS set until the number of pulses output is near the P (I) set. 7-27 (1+N)th axis HW LW SR1025+100*N SR1024+100*N (1+N)th axis HW LW - SR1030+100*N Special data register SR1030+100*N b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0 - - - The execution of the Ox motion subroutine set starts. A mode of inserting two-speed motion is activated. A mode of two-speed motion is activated. A mode of inserting single-speed motion is activated.

A mode of single-speed motion is activated. - A mode of triggering the return to home is activated. A manual pulse generator is operated. A mode of variable motion is activated. The axis specified operates in JOG- mode. The axis specified operates in JOG+ mode. - The motion of the axis specified is stopped by software.