Mitsubishi — 7.8.1 Related Special Data Registers

AH500 Motion Control Module Manual  Absolute single-speed motion: If the target position of the axis specified is greater than its present command position, the motor used will rotate clockwise. If the target position of the axis specified is less than its present command position, the motor used will rotate counterclockwise. After absolute single-speed motion is activated, the speed of the absolute single-speed motion will increase from the V BIAS set to the V (I) set. The speed of the absolute single-speed motion will not decrease from the V (I) set to the V BIAS set until the present command position of the axis specified is near the target position (P (I)) set.

Velocity Time Start 7.8 Introduction of Inserting Single-speed Motion 7.8.1 Related Special Data Registers 1. Target position of the axis specified (P (I)) [Description]  The value in (SR1023+100*N, SR1022+100*N) is in the range of -2,147,483,648 to +2,147,483,647. (The unit used is determined by bit 0 and bit 1 in SR1000+100*N.)  Target position (P (I)) After motion is triggered by a transition in DOG’s signal from low to high or from high to low, the axis specified will move from its present command position to the target position (P (I)) set. If the relative target position specified is a positive value, the motor used will rotate clockwise.

If the relative target position specified is a negative value, the motor used will rotate counterclockwise. 2. Speed at which the axis specified rotates (V (I)) [Description]  When an axis operates, users can not change its V (I) at will.  Please refer to section 7.7 for more information. 7-28 T ACC T ACC T DEC (1+N)th axis HW LW SR1023+100*N SR1022+100*N (1+N)th axis HW LW SR1025+100*N SR1024+100*N