Mitsubishi — 7.9.2 Operation

Chapter 7 Uniaxial Motion 4. Speed at which the axis specified rotates(V (II)) [Description]  The value in (SR1029+100*N, SR1028+100*N) is in the range of 0 to 2,147,483,647. (The unit used is determined by bit 0 and bit 1 in SR1000+100*N.)  The frequency of pulses generated by motion is in the range of 10 PPS to 1000K PPS. If the value in (SR1029+100*N, SR1028+100*N) is greater than 1000K, the frequency of pulses generated will be 1000K PPS. If the value in (SR1029+100*N, SR1028+100*N) is less than 10, the frequency of pulses generated will be 10 PPS.  V MAX > V (II) > V BIAS  When an axis operates, users can not modify its V (II). 5.

Operation command [Description]  If users want to activate a mode of two-speed motion, they have to set bit 10 in SR1030+100*N to 1. 7.9.2 Operation  After bit 10 in SR1030+100*N is set to 1, a mode of two-speed motion will be activated. The axis specified moves at the V (I) set. After it moves to the P (I) set, it will move to the P (II) set at the V (II) set.  Relative coordinates: The sign bit of the P (I) set by users determines the direction of motion. If the P (I) specified is a positive value, the motor used will rotate clockwise. If the P (I) specified is a negative value, the motor used will rotate counterclockwise.

If the P (I) specified is a positive value, the P (II) is also a positive value. If the P (I) specified is a negative value, the P (II) is also a negative value. After motion is started, the speed of the motion will increase from the V BIAS set to the V (I) set. The speed of the motion will not increase/decrease from the V (I) set to the V (II) set until the number of pulses output is near the P (I) set. The speed of the motion will not 7-31 (1+N)th axis HW LW SR1029+100*N SR1028+100*N (1+N)th axis HW LW - SR1030+100*N Special data register SR1030+100*N b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0 - - - The execution of the Ox motion subroutine set starts.

A mode of inserting two-speed motion is activated. A mode of two-speed motion is activated. A mode of inserting single-speed motion is activated. A mode of single-speed motion is activated. - A mode of triggering the return to home is activated. A manual pulse generator is operated. A mode of variable motion is activated. The axis specified operates in JOG- mode. The axis specified operates in JOG+ mode. - The motion of the axis specified is stopped by software.