Mitsubishi — 7.10.1 Related Special Data Registers

AH500 Motion Control Module Manual decrease from the V (II) to the V BIAS set until the number of pulses output is near the P (II) set.  Absolute coordinates: If the target position (P (I)) of an axis is greater than its present command position, the motor used will rotate clockwise. If the target position (P (I)) of an axis is less than its present command position, the motor used will rotate counterclockwise. The P (I) set must be between the present command position of the axis specified and the P (II) set. After motion is started, the speed of the motion will increase from the V BIAS set to the V (I) set.

The speed of the motion will not increase/decrease from the V (I) set to the V (II) set until the present command position of the axis specified is near the P (I) set. The speed of the motion will not decrease from the V (II) to the V BIAS set until the present command position of the axis specified is near the P (II) set. Velocity Time Start 7.10 Introduction of Inserting Two-speed Motion 7.10.1 Related Special Data Registers 1. Speed at which the axis specified rotates (V (I)) [Description]  When an axis operates, users can not change its V (I) at will.  Please refer to section 7.7 for more information. 2.

Speed at which the axis specified rotates(V (II)) [Description] Please refer to section 7.9 for more information. 3. Target position of the axis specified (P (II)) [Description]  The value in (SR1027+100*N, SR1026+100*N) is in the range of -2,147,483,648 to +2,147,483,647. (The unit used is determined by bit 0 and bit 1 in SR1000+100*N.)  Target position (P (II)) After motion is triggered by a transition in DOG’s signal from low to high or from high to low, the 7-32 T T ACC DEC V MAX P(I) V(I) P(II) V(II) V BIAS V(I) V BIAS (1+N)th axis HW LW SR1025+100*N SR1024+100*N (1+N)th axis HW LW SR1029+100*N SR1028+100*N (1+N)th axis HW LW SR1027+100*N SR1026+100*N