Mitsubishi — 7.10.2 Operation

Chapter 7 Uniaxial Motion axis specified will move from its present command position to the target position (P (II)) set. If the relative target position specified is a positive value, the motor used will rotate clockwise. If the relative target position specified is a negative value, the motor used will rotate counterclockwise. 4. Operation command [Description]  If users want to activate a mode of inserting two-speed motion, they have to set bit 11 in SR1030+100*N to 1. 7.10.2 Operation  After bit 11 in SR1030+100*N is set to 1, a mode of inserting two-speed motion will be activated. The axis specified moves at the V (I) set.

After DOG’s signal goes from low to high or from high to low, the axis will move to the relative target position indicated by the P (II) set at the V (II) set.  If the target position (P (II)) specified is a positive value, the motor used will rotate clockwise. If the target position (P (II)) specified is a negative value, the motor used will rotate counterclockwise.  After motion is started, the speed of the motion will increase from the V BIAS set to the V (I) set. After DOG’s signal goes from low to high or from high to low, the speed of the motion will increase/decrease from the V (I) set to the V (II) set.

The motion will not stop until the number of pulses output is near the P (II) set. 7-33 (1+N)th axis HW LW - SR1030+100*N Special data register SR1030+100*N b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0 - - - The execution of the Ox motion subroutine set starts. A mode of inserting two-speed motion is activated. A mode of two-speed motion is activated. A mode of inserting single-speed motion is activated. A mode of single-speed motion is activated. - A mode of triggering the return to home is activated. A manual pulse generator is operated. A mode of variable motion is activated. The axis specified operates in JOG- mode. The axis specified operates in JOG+ mode.

- The motion of the axis specified is stopped by software.