Chapter 9 Multiaxial Interpolation 0002 0003 Description: P 1 : Target position of an x-axis; P 2 : Target position of a y-axis; P 3 : Target position of a z-axis; P 4 : Vector from the present position of an x-axis to an arc center; P 5 : Vector from the present position of an y-axis to an arc center; P 6 : Vector from the present position of an z-axis to an arc center; V : Speed of circular/helical interpolation P 4 , P 5 and P 6 :
Vectors from the present positions of an x-axis, a y-axis, and a z-axis to an arc center If the value of P 1 / P 2 / P 3 / P 4 / P 5 / P 6 is not a floating-point value, it must be in the range of -2,147,483,648 to 2,147,483,647, and the value of V must be in the range of 0 to 500,000. If the value of P 1 / P 2 / P 3 / P 4 / P 5 / P 6 is a floating-point value, it must be in the range of-2,147,483.648 to 2,147,483.647, and the value of V must be in the range of 0 to 500.0. If users specify a speed for G02/G03, the speed of circular/helical interpolation will be the speed specified.
If no speed is specified for the instruction, the speed of circular/helical interpolation will be the speed specified for G01/G02/G03 which precedes G02/G03. V : Maximum speed of circular/helical interpolation Operation Velocity Maximum speed Number of pulses output Start-up speed Time Time it takes for the axis specified to decelerate Time it takes for the axis specified to accelerate Users can set the time it takes for an axis specified to accelerate/decelerate and the start-up speed of the axis by means of special data registers. The time it takes for an axis specified to accelerate/decelerate is proportional to the maximum speed of the axis.
9-9 Instruction code Operand Function G02 G03 X P 1 Y P 2 Z P 3 I P 4 J P K P F V 5 6 Clockwise circular/helical interpolation Counterclockwise circular/helical interpolation (arc center) Device K 16# F D DD W WW P 1 P 2 P 3 P 4 P 5 P 6 V