Mitsubishi — 9.4 Descriptions of G-code Instructions

Chapter 9 Multiaxial Interpolation 0002 0003 Description:  P 1 : Target position of an x-axis; P 2 : Target position of a y-axis; P 3 : Target position of a z-axis; L : Arc radius (If the angle subtended by an arc is less than 180°, the value of R is a positive value. If the angle subtended by an arc is greater than 180°, the value of R is a negative value.); V : Speed of circular/helical interpolation  If the value of P 1 / P 2 / P 3 / L is not a floating-point value, it must be in the range of -2,147,483,648 to 2,147,483,647, and the value of V must be in the range of 0 to 500,000.

If the value of P 1 / P 2 / P 3 / L is a floating-point value, it must be in the range of-2,147,483.648 to 2,147,483.647, and the value of V must be in the range of 0 to 500.0.  L : If the angle subtended by an arc is less than 180°, the value of R is a positive value. If the angle subtended by an arc is greater than 180°, the value of R is a negative value.  If users specify a speed for G02/G03, the speed of circular/helical interpolation will be the speed specified. If no speed is specified for G02/G03, the speed of circular/helical interpolation will be the speed specified for G01/G02/G03 which precedes G02/G03.  V :

Maximum speed of circular/helical interpolation  Operation Velocity Maximum speed Start-up speed Number of pulses output Time Time it takes for the axis specified to decelerate Time it takes for the axis specified to accelerate  Users can set the time it takes for an axis specified to accelerate/decelerate and the start-up speed of the axis by means of special data registers.  The time it takes for an axis specified to accelerate/decelerate is proportional to the maximum speed of the axis.

9-15 Instruction code Operand Function G02 G03 X P Y P Z P R L 1 2 3 F V Clockwise circular/helical interpolation Counterclockwise circular/helical interpolation (radius) Device K 16# F D DD W WW P 1       P 2       P 3       L       V      