AH500 Motion Control Module Manual Circular interpolation: Two axes which are perpendicular to each other are used. G17, G18, or G19 is used to control circular interpolation. +R End point ( ) P P 1, 2 End point ( ) P P 1, 2 -R Center point Center point -R +R Center point Center point Start point (present position) Start point (present position) Helical interpolation: Three axes which are perpendicular to one another are used. They move synchronously. Helical interpolation is the extension of circular interpolation. If a helical interpolation instruction is used, and the change of height is zero, circular interpolation will be executed.
If G17 is used, and the position of a z-axis does not change, helical interpolation will be equivalent to circular interpolation. G03 (Counterclockwise interpolation) G02 (Clockwise interpolation) Z-axis End point End point (x, y, z) Z-axis (x, y, z) End point End point ( x, y) ( x, y) Y-axis Y-axis R (Radius) R (Radius) R (Radius) Center point Center point Center point Center point X-axis X-axis R (Radius) Start point Start point Z=0 Z=0 Z=0 Z=0 Start point Start point G03 (Counterclockwise interpolation) G02 (Clockwise interpolation) If G18 is used, and the postion of a y-axis does not change, helical interpolation will be equivalent to circular interpolation.
Z-axis End point End point Z-axis (x, y, z) End point (x, y, z) ( x, y) ( x, y) End point Y-axis Y-axis R (Radius) R (Radius) Center point Center point Center point R (Radius) R (Radius) X-axis Center point X-axis Start point Start point Start point Start point Z=0 Z=0 Z=0 Z=0 G03 (Counterclockwise interpolation) G02 (Clockwise interpolation) 9-16