Chapter 9 Multiaxial Interpolation If G19 is used, and the postion of an x-axis does not change, helical interpolation will be equivalent to circular interpolation. Z-axis Z-axis Center point End point Center point Center point Start point End point ( x, y, z) ( y, z) End point ( x, y, z) R (Radius) R (Radius) R (Radius) ( y, z) X=0 End point Center point Start point X=0 R (Radius) X-axis Start point X-axis Start point X=0 Y-axis X=0 Y-axis G03 (Counterclockwise interpolation) G02 (Clockwise interpolation) Principles of writing an instruction: (1) Users have to specify a target position, and an arc center. They do not have to specify the speed of interpolation.
(2) If there is no vector from the present position of an axis to its target position, users do not need to specify the target position of the axis. The circular/helical instrctions listed below are available. The path of circular interpolation can not be a 360° arc. The path of helical interpolation which is viewed from the top can not be a full circle. Example 1 Absolute coordinates are set, and G02 is used. The arc start point set is (5000, 5000), the arc end point set is (10000, 10000), and L is 5000. The angle subtended by the arc is less than 180°, and therefore the value of R is a positive value. The axes move at a speed of 1,000 per second. 9-17 NO.
G-code Combination of operands G17 G18 G19 1 G02/G03 X P R L 1 2 X P R L F V 1 3 Y P R L 2 4 Y P R L F V 2 5 X P Y P R L 1 2 6 X P Y P R L F V 1 2 7 X P Z P R L 1 3 8 X P Z P R L F V 1 3 9 Y P Z P R L 2 3 10 Y P Z P R L F V 2 3 11 X P Z P Y P R L 1 3 2 12 X P Z P Y P R L F V 1 3 2 13 Z P R L 3 14 Z P R L F V 3