Delta Electronics AH500 — 8.2.5.5 Ethernet─Advance: Email and Trigger Configuration

AH500 Operation Manual  PLC Device If this option button is selected, the system automatically retrieves the states of the devices, or the values in the devices listed in the table as the attachment when the email is sent. After this option button is selected, users can double-click the table to open the Attachment window. Two groups of devices at most can be set. For example, if the condition is met, the values in D0~D9 will be sent as an attachment. (5) After all the setting is complete, users can click OK to create the trigger. *. The parameters set in HWCONFIG must be downloaded to the CPU module so that they can take effect.

(Please refer to section 8.2.6 or section 8.4.4 for more information.) 8.2.5.5 Ethernet ─ Advance: Email and Trigger Configuration After users click the Ethernet─Advance tab at the top of the window, and the Email and Trigger Configuration tab at the bottom of the window, they can set the relation between triggers for the sending of emails and receivers. Before setting the function here, the users have to click the Email tab, select the Enable Email Sending Function checkbox, click the Email Trigger tab, and set at least one trigger. Please refer to section 8.2.5.3 and section 8.2.5.4 for more information. First, type the email addresses of receivers in the Email Address column.

Eight email addresses at most can be set for the CPU module, and every email address is composed of sixty-four characters at most. Then, select triggers corresponding to receivers. If email addresses or triggers are not set, the corresponding selection 8-45