EPSON — Status and error messages on the control panel

AL-C300 Series User's Guide Troubleshooting To clear this warning message, select Clear Warning from the control panel’s Reset Menu . Duplex Memory Overflow (AL-C300DN only) There is not enough memory for duplex printing. The printer prints only on the front and ejects the paper. To clear this error, follow the instructions below. Check Paper Size The paper size setting is different from the size of paper loaded in the printer. Check to see if the correct size of paper is loaded in the specified paper source. If Off is selected as the Auto Cont setting on the control panel’s Setup Menu , press the OK button to print on the back of the next sheet, or cancel the print job.

To cancel the print job, see “Cancelling a Print Job” on page 54 . To clear this warning message, select Clear Warning from the control panel’s Reset Menu . Clear Paper Jam wwww If On is selected as the Auto Cont setting on the control panel’s Setup Menu , printing continues automatically after a certain period of time. The location where the paper jam occurred is displayed at WWWWW . WWWWW indicates the location of the error. If a paper jam occurs at two or more locations simultaneously, the corresponding multiple locations are displayed. Feed Roller C1 Needed Soon, Feed Roller C2 Needed Soon This warning message indicates that the feed roller C1 or C2 is near the end of its service life.

You can continue to print until the Replace Feed Roller C1 or Replace Feed Roller C2 message appears. For details about clearing paper jams, see “Clearing Jammed Paper” on page 66 . Close Cover wwww Form Data Canceled The specified cover ( wwww ) does not close securely. Open the cover once, and then close. Unable to store form overlay data on the optional CompactFlash memory. Either the CompactFlash memory is not installed correctly, or the maximum number of form overlay files has been reached. Confirm that the optional CompactFlash memory is installed correctly, or delete any form overlay files you no longer need, and then try storing the new overlay again.

Collate Disabled Printing by specifying the number of copies is no longer possible due to a lack of memory (RAM). If this warning message appears, print only one copy at a time. To clear this error, select Clear Warning from the control panel’s Reset Menu . To clear this warning message, select Clear Warning from the control panel’s Reset Menu . Form Feed CompactFlash Error The printer is ejecting paper due to a user request. This message appears when pressing the Pause/Release button once, then holding down the OK button for more than 2 seconds because the printer has not received a form feed command.

The installed CompactFlash memory is not supported by the printer or you selected No when the Format Required was displayed on the control panel. Turn off the printer and remove the CompactFlash memory. If Format Required is displayed on the control panel, select Yes . Format Required CompactFlash Full The installed CompactFlash memory needs to be formatted to use it with the printer. Select Yes to format the memory, or select No to cancel formatting. If you select No , CompactFlash Error is displayed and you cannot use the memory for the printer. In that case, turn off the printer and remove the CompactFlash memory. The optional CompactFlash memory is full and you cannot save any data.

Delete the unnecessary data from the CompactFlash memory. To clear this warning message, select Clear Warning from the control panel’s Reset Menu . Formatting CF 61