EPSON — Status and error messages on the control panel

AL-C300 Series User's Guide Troubleshooting This warning message indicates that the photoconductor unit is near the end of its service life. Reboot to apply settings You selected No when Do you want to reboot to apply the settings? was displayed. To clear this warning message, select Clear Warning from the control panel’s Reset Menu . The letters C, M, Y, or K appear in place of uuuu and indicate the colors Cyan, Magenta, Yellow, and Black respectively. You can continue to print until the Replace Photoconductor message appears. Replace 2nd Transfer Unit Photocon Trouble uuuu The 2nd transfer unit has reached the end of its service life and needs to be replaced.

Press the OK button to clear this error. There is a problem with the photoconductor unit. The letters C, M, Y, or K appear in place of uuuu and indicate the colors Cyan, Magenta, Yellow, and Black respectively. Remove the photoconductor unit and reinsert it. If that fails to clear the error, replace the photoconductor unit with a new one. For details about replacement, see the instructions that come with the photoconductor unit. Replace Feed Roller C1, Replace Feed Roller C2 The feed roller C1 or C2 has reached the end of its service life and needs to be replaced. Press the OK button to clear this error.

Please Wait Replace Fuser The fuser has reached the end of its service life and needs to be replaced. Press the OK button to clear this error. For details about replacement, see the instructions that come with the fuser unit. ! Caution: Printing cannot start because the previous job is being processed. Try again after a few seconds. Print Overrun The required time to process the print data exceeded the print engine speed because the current page is too complex. Press the OK button to resume printing, or cancel the print job. To cancel the print job, see “Cancelling a Print Job” on page 54 .

If this message appears again, select On as the Page Protect setting in the control panel’s Setup Menu . If the printer has been in use, the fuser and the surrounding areas may be very hot. If you must touch one of these areas, turn off the printer and wait 40 minutes to allow the heat to subside before doing so. Replace Photocon uuuu The photoconductor unit has reached the end of its service life and needs to be replaced. If you continue to receive this message when printing a particular page, try simplifying the page by limiting the number of graphics or reducing the number and size of fonts.

The letters C, M, Y, or K appear in place of uuuu and indicate the colors Cyan, Magenta, Yellow, and Black respectively. If the error light blinks, press the OK button to clear this error. For details about replacement, see the instructions that come with the photoconductor unit. PS3 CompactFlash Full The memory allocated for writing PostScript 3 commands on the optional CompactFlash memory is full. To clear this warning message, select Clear Warning from the control panel’s Reset Menu . Replace Toner uuuu The toner cartridge has reached the end of its service life and needs to be replaced. RAM CHECK The printer is checking the RAM.

The letters C, M, Y, or K appear in place of uuuu and indicate the colors Cyan, Magenta, Yellow, and Black respectively. For details about replacement, see the instructions that come with the toner cartridge. Ready The printer is ready to receive data and print. Replace Toner uuuu Print in monochrome? 63