AL-C300 Series User's Guide Troubleshooting Printout Problems Print quality is poor Refer to the table below if your printouts are light, faint, uneven, dark, or dirty or if some areas are not printed. 72 Cause What to do You may not be using the correct type of paper for your printer. Smooth, high-quality copier paper is recommended for best results. See “Available Paper and Capacities” on page 37 for information on choosing paper. Your paper may be moist or damp. Do not store your paper in a humid or damp environment. The paper type setting may not be appropriate for the loaded paper. Set the appropriate paper type in the printer driver. Adjust the TR settings in the Printer Adjust Menu.
See “Printer Adjust Menu” on page 90 for details. The Toner Save mode may be on. Turn off the Toner Save mode using the printer driver or the printer’s control panel menus. For Windows users, on the More Options tab in the printer driver, click Image Options and select the Toner Save check box. The paper path inside the printer may be dusty. Clean internal printer components by printing three pages with only one character per page. If the printouts get dirty, clean the paper feed roller. See “Cleaning the roller” on page 80. The Highland setting may not be set correctly for printing in a location at a high altitude. Select the appropriate value in Highland of the Printer Adjust Menu.
See “Printer Adjust Menu” on page 90. The fixing temperature may not be appropriate. Try to lower or raise the temperature by adjusting the Temp settings in the Printer Adjust Menu. See “Printer Adjust Menu” on page 90 for details. However, do this at your own risk, as lowering the temperature too far may prevent the toner from fixing to the paper and raising the temperature too far may cause the paper to curl. Photoconductor units are not set correctly. If you transport the printer without using packing materials to immobilize photoconductor units, the units may come off during the transportation. If this happens you must reinstall each photoconductor unit.
For information about transporting the printer, see “For long distances” on page 84. For information on reinstalling the photoconductor unit, see the instructions that came with the photoconductor unit. There may be problems with replacement parts (toner cartridges, photoconductor units, fuser unit), or there may be replacement parts that have come to near the end of the service lives. Print several pages to check if the quality of the printouts has improved. If it has not improved, replace the replacement parts with new parts in the following order:
- Toner cartridges - Photoconductor units - Fuser unit For information about replacing parts, see the instructions that come with each replacement parts.