• If a device running VTP version 1, but capable of running VTP version 2, receives VTP version 3 advertisements, it automatically moves to VTP version 2. • If a device running VTP version 3 is connected to a device running VTP version 1, the VTP version 1 device moves to VTP version 2, and the VTP version 3 device sends scaled-down versions of the VTP packets so that the VTP version 2 device can update its database. • A device running VTP version 3 cannot move to version 1 or 2 if it has extended VLANs. • Do not enable VTP version 2 on a device unless all of the devices in the same VTP domain are version-2-capable.
When you enable version 2 on a device, all of the version-2-capable devices in the domain enable version 2. If there is a version 1-only device, it does not exchange VTP information with device that have version 2 enabled. • Cisco recommends placing VTP version 1 and 2 device at the edge of the network because they do not forward VTP version 3 advertisements. • If there are TrBRF and TrCRF Token Ring networks in your environment, you must enable VTP version 2 or version 3 for Token Ring VLAN switching to function properly. To run Token Ring and Token Ring-Net, disable VTP version 2.
• For VTP version 1 and version 2, the device must be in VTP transparent mode when you create extended-range VLANs. VTP version 3 also supports creating extended-range VLANs in client or server mode. • When a VTP version 3 device trunk port receives messages from a VTP version 2 device, it sends a scaled-down version of the VLAN database on that particular trunk in VTP version 2 format. A VTP version 3 device does not send VTP version 2-formatted packets on a trunk unless it first receives VTP version 2 packets on that trunk port.
• When a VTP version 3 device detects a VTP version 2 device on a trunk port, it continues to send VTP version 3 packets, in addition to VTP version 2 packets, to allow both kinds of neighbors to coexist on the same trunk. • A VTP version 3 device does not accept configuration information from a VTP version 2 or version 1 device. • Two VTP version 3 regions can only communicate in transparent mode over a VTP version 1 or version 2 region. • Devices that are only VTP version 1 capable cannot interoperate with VTP version 3 devices. How to Configure VTP The following sections provide information about Configuring VTP: Configuring VTP Mode You can configure VTP mode as one of these:
• VTP server mode—In VTP server mode, you can change the VLAN configuration and have it propagated throughout the network. Configuring VTP How to Configure VTP VLAN Configuration Guide, Cisco IOS XE 17.16.x (Catalyst 9300 Switches) 9