3-4 Drive Expansion The video slot connector has been extended compared with previous Amiga models to make graphics signals produced by the AA custom chip set available. Most boards produced for the earlier video slot are still electrically compatible with the newer slot. The rear bracket of video boards produced for earlier Amigas, however, may require some modification to fit the A4000 chassis. The A4000 contains a built-in Intelligent Drive Electronics (lDE) hard disk controller, to which one or two devices may be connected internally via the ribbon cable included.
You can use one of the Amiga expansion slots to add a SCSI adapter, which could then control additional internal and external storage equipment, such as CD-ROM drives, tape drives, scanners, and so on. The Amiga has ample space and mounting hardware for internal drive expansion, allowing both 3.5-inch and 5.25-inch devices. The A4000 can accommodate up to four 3.5-inch devices internally. The two front bays (one already filled by the internal floppy drive) have external access; the two in the rear position are suitable for hard drives that do not require external access.
Note In order for two devices to be installed in either the front or the rear 3.5-inch bays, both devices in either area must be low profile units (1 inchl25 mm in height). If a half-height (1.25 inchl32 mm) device is installed in either area, another device cannot be installed in that area. You can install a second floppy drive (DF1:) in the bottom front 3.5- inch bay, provided that the DFO: floppy drive is a low profile unit. Additional floppy drives (DF2: and DF3:) may be connected externally using the floppy drive connector on the rear of the main unit. Drive Expansion 3.S-lnch Devices