4-5 8.DOOOOOODDOOD8000DDD80DDDDDD.;;!;;8080D80D80D80D80DD80ODODD80D~ After installing additional memory and replacing the Amiga's cover, check to be sure that the memory is functioning properly. Normally, any new RAM is automatically recognized by the operating system when the Amiga is turned on. The Workbench screen's title bar displays the amounts of available Chip ("graphics") and Fast ("other") memory. If the Workbench title bar display does not reflect the amount of memory that you installed, or if the Amiga will not boot, there is a problem.
Turn off the Amiga, disconnect and open it, and check that the SIMMs are all seated in the proper banks, that the SIMMs in the Fast RAM section are all of the same memory size, and that the SIMM SIZE jumper is set appropriately. Should you still have problems after confirming that the installation was correct, one or more of the SIMMs either is not of the proper type or is damaged. f:ODOOrR'O~~'D.'\ 6. Change the setting ofthe SIMM SIZE jumper if necessary. 9. Reconnect peripherals and power and check that the new memory is recognized. Figure 4-2. Inserting a SIMM into a socket 7. Replace any expansion boards you removed. Testing Memory Installation 8. Replace the Amiga's cover.
Adding Memory