AS Series Module Manual Example: If the gain is 1000 and the offset is 0, the corresponding value for the original signal 0° C to 100° C is 0–1000. If you change the offset to 100, the calibrated value for the original signal 0° C to 100° C becomes 100–1100. 100 C O Signals after the calibration 0 -32000 (X) Input analog value (Y) 4. Average You can set the average value between 1–100. It is a steady value obtained from the sum of the recorded values. If the recorded values include an acute pulse due to unavoidable external factors, however, you may observe violent changes in the average value.
Use the filtering function to exclude the acute pulses from the sum-up and equalization, so the computed average value is not affected by the acute recorded values. Set the filter percentage to the range 0–3, where the unit is 10%. If you set the filter range to 0, the _6 system sums up all the recorded values and divides them to obtain the average value, but if you set the filter range to 1, for example, the system excludes the bottom 10% and the top 10% of the values and averages only the remaining values to obtain the average value. Quantity Present measured value 5. Disconnection Detection module produces an alarm or a warning.
If the channel is open, the module can detect when it is disconnected. If the input is open-circuited, the 6-16 Original signals 100 1000 110 Digitalva Range for filt