Delta Electronics — 8.2.4 Control Registers

AS Series Module Manual CR#200: Codes for the state register Explanation CR#201: Command set Explanation _8 8-10 Bit Code Definition Bit Code Definition b0 16#0001 Error exists in the power supply. b1 16#0002 Error exists in the module hardware. b2 16#0004 Error exists in the driver board. b3 16#0008 Calibration disabled b4 16#0010 Reserved b5 16#0020 Reserved b6 16#0040 The weight measured by CH1 exceeds the maximum weight that can be measured, or the voltage of SEN is incorrect. b7 16#0080 The weight measured by CH2 exceeds the maximum weight that can be measured, or the voltage of SEN is incorrect. b8 16#0100 The weight measured by CH1 exceeds the maximum weight that can be measured.

b9 16#0200 The weight measured by CH2 exceeds the maximum weight that can be measured. b10 16#0400 CH1 has been adjusted incorrectly. b11 16#0800 CH2 has been adjusted incorrectly. b12 16#1000 CH1 is not measuring any weight. b13 16#2000 CH2 is not measuring any weight. b14 16#4000 The weight measured by CH1 is in the stability range specified. b15 16#8000 The weight measured by CH2 is in the stability range specified. Note: The state is determined by the corresponding bit and it is possible to have more than 2 states at the same time. Input Description Input value Description value 0 No action 16#0101 Start a new recording of the peak value for CH1.

1–20 Commands for calibrating the calibration points 1–20 on CH1 16#0102 Start a new recording of the peak value for CH2. 21–40 Commands for calibrating the calibration points 1–20 on CH2 16#010F Start a new recording of the peak value for CH1 - CH2. 98 Activate the weight calibration. 16#0201 Start a new recording for CH1. 99 Deactivate the weight calibration. 16#0202 Start a new recording for CH2.