Delta Electronics — 11.4.3.1. Data Mapping between Modules and AS PLC

Chapter 11 DeviceNet Master Scanner Module AS01DNET-A 11.4.3 IO Mapping for AS01DNET in AS PLC 11.4.3.1. Data Mapping between Modules and AS PLC Up to four AS01DENT modules can be connected to the right side of AS PLC at most. After AS01DNET modules and 11 PLC are connected, PLC will assign data mapping areas to each module. POWER 01DNET 01DNET 01DNET 01DNET RTU Master Slave / RTU Master Slave / RTU Master Slave / RTU Master Slave / second module is 2, the third module is 3 and the fourth module is 4. The position is only defined for network modules such AS01DNET modules are connected to the right of the PLC.

The position of the first module on the right of AS PLC is 1, the as AS01DNET and AS00SCM, instead of digital modules, analog modules, temperature modules, and weight- measurement modules. The positions of AS01DNET modules on the right of the PLC are shown in the following table where there are two arrangement ways of module connections. 11-15 RUN ERROR BAT.

LOW COM1 COM2 AS324MT 0 8 1 9 2 10 3 11 IN 4 5 6 7 0 8 1 9 Ethernet 2 10 3 11 OUT 4 5 6 7 40 2 1 I I NS x10 N 0 N 1 Node Add x10 I ress I NS x10 N 0 N 1 Node Ad x10 I dress I NS x10 N 0 N 1 Node Ad x10 I dress I NS x10 N 0 N 1 Node Ad x10 dress OUT Example 1 Example 2 Position of AS01DNET on the right of the PLC Arrangement order of AS PLC and modules on the right of the PLC Position of AS01DN on the right of the P ET LC o Arrangement order of AS PLC and modules n the right of the PLC AS PLC AS PLC 1 AS01DNET 1 AS01DNET AS04AD AS04AD 2 AS01DNET AS00SCM 3 AS01DNET