ASDA-B3 Wiring IP67 waterproof connector ends: 3 View from this side View from this side 1 7 2 6 2 4 6 3 8 5 1 3 5 4 Pin assignment of CN2 connector: Note: for the absolute battery wiring, refer to Section 3.1.5 Specification for the encoder connector. Connecting shielded wire to the CN2 encoder connector is shown as follows: Step 1: Cut through the cable and expose the shielding. The exposed wire length should be 20 - 30 mm (0.79 - 1.18 inches). Step 2: Spread the metal shielding and fold it back. Refer to the CN2 pin assignment (see the table above) to connect the pins. 3-57 The end that connects to the encoder The end that connects to the servo drive Military Quick IP67 Color Pin No.
Signal Description connector connector connector 4 7 4 Brown 1 DC+5V +5V power supply 9 8 3 Blue 2 GND Power ground - - - - 3 - Do not connect this pin. For internal use only. - - - - 4 - Do not connect this pin. For internal use only. 1 1 1 White 5 T+ Serial communication signal (+) 2 4 2 White / Red 6 T- Serial communication signal (-) 10 9 8 - Case Shield Shielding 6 2 6 Red - - Battery +3.6V 5 5 5 Black - - Battery ground