Delta Electronics — 4.3.5 Monitoring display

ASDA-B3 Test Operation and Panel Display 4.3.3 Alarm messages 4 4.3.4 Positive and negative sign setting 4.3.5 Monitoring display When you apply power to the drive, the display shows the monitoring displayed symbol for one second, and then enters Monitoring mode. In Monitoring mode, press the UP ( ▲ ) and DOWN ( ▼ ) keys to change the monitoring variables. Or you can directly change the setting value of P0.002 to specify the monitoring code. When powered, the default monitoring code is determined by the value of P0.002. For example, the value of P0.002 is 4. When the drive is powered, it displays the monitoring symbol C-PLS first, and then shows the input number of pulse commands.

Refer to the following table for more information. 4-7 Displayed symbol Description When an alarm occurs, the servo drive shows ‘AL’ as the alarm symbol and ‘nnn’ as the alarm code. Refer to Chapter 8 Parameters for a detailed description of P0.001 or Chapter 12 Troubleshooting for alarm details. Displayed symbol Description In Editing mode, press the UP (▲) and DOWN (▼) keys to change the displayed value. Press the SHIFT key to change the selected value (the selected value is flashing). Press the SHIFT key for two seconds to switch between the positive (+) and negative (-) signs.

If the parameter value is out of range after switching the positive or negative sign, then the servo drive automatically resets it to the original value.

P0.002 Monitoring displayed Description Unit setting value symbol 0 Motor feedback pulse number (after the scaling of E-Gear ratio) (user unit) [user unit] 1 Input number of pulse commands (after the scaling of E-Gear ratio) (user unit) [user unit] 2 The deviation between control command pulse and feedback pulse number (user unit) [user unit] 3 Motor feedback pulse number (encoder unit) [pulse] 4 Input number of pulse commands (before the scaling of E-Gear ratio) (encoder unit) [pulse] 5 Error pulse number (after the scaling of E-Gear ratio) (encoder unit) [pulse] 6 Input frequency of pulse commands [kpps] 7 Motor speed [rpm] 8 Speed command [Volt] 9 Speed command [rpm]