Operation Mode ASDA-B3 6.2.6 Low-pass filter 6 Target position P1.008 Refer to Chapter 8 for detailed descriptions of the relevant parameter. 6.2.7 Timing diagram of PR mode In PR mode, the Position command is issued with the DI signals (POS0 - POS6 and CTRG) of CN1. Refer to Section 6.2.2 for information about the DI signal and its selected register. The timing diagrams are shown as follows. Internal register (PR#0 - 99) Motion curve (speed) POS0 POS1 External DI POS2 CTRG SON Internal DO Note: Cmd_OK is on when the PR command is complete; TPOS is on when the error is smaller than the value set by P1.054; MC_OK is on when Cmd_OK and TPOS are both on.
6-10 Parameter Function P1.008 Position command smoothing constant (low-pass filter) PR#1 PR#2 PR#4 1 ms on off off 0 off on off 1 off on 2 G on N the response time with P2.009 off on OK _ off on OS off on OK _ 1 ms on off 0 off on 1 off 2 G on N the response time with P2.009 off OK _ off OS off OK _ 1 ms on off off off on on on on