Delta Electronics — 6.3.3 Smooth Speed command

ASDA-B3 Operation Mode 6.3.3 Smooth Speed command S-curve filter During the process of acceleration or deceleration, the S-curve filter uses the three-stage 6 acceleration curve and creates a smoother motion trajectory. It avoids jerk (rapid change of acceleration), resonance, and noise caused by abrupt speed variation. You can use the following parameters for adjustment. The S-curve acceleration constant (P1.034) adjusts the slope of the change in acceleration. The S-curve deceleration constant (P1.035) adjusts the slope of the change in deceleration. The S-curve acceleration / deceleration constant (P1.036) improves the status of motor activating and stopping.

The servo drive can also calculate the total time for executing the command. T (ms) indicates the operation time and S (rpm) indicates the absolute Speed command, which is the absolute value of the initial speed minus the end speed. Speed Rated speed 0 Time (ms) Torque (ms) 0 Time P1.036 P1.035 2 P1.036 2 Figure 6.3.3.1 S-curve and time setting Refer to Chapter 8 for detailed descriptions of the relevant parameters. 6-17 Acceleration Deceleration e P1.036 P1.034 P1.036 2 2 Parameter Function P1.034 S-curve acceleration constant P1.035 S-curve deceleration constant P1.036 S-curve acceleration / deceleration constant