Delta Electronics — 6.3.3 Smooth Speed command

Operation Mode ASDA-B3 S-curve filter for analog commands The S-curve filter for analog commands helps to stabilize the motor operation when the analog 6 input signal (speed) changes rapidly. Speed (rpm) (1) Analog Speed command; (2) Motor speed The S-curve filter for analog commands smoothes the analog input signal. Its time program is the same as the S-curve filter mentioned in the above paragraph. Also, the speed and acceleration curves are both continuous. The above graph shows the S-curve and the motor speed when you apply the S-curve filter for analog commands. The slopes of the Speed command in acceleration and deceleration are different.

Adjust the time settings (P1.034, P1.035, and P1.036) according to the actual application to improve the performance. Low-pass filter for Speed commands You usually use the low-pass filter to remove unwanted high-frequency response or noise so that the speed change is smoother. Refer to Chapter 8 for detailed descriptions of the relevant parameter. Speed command Target speed t P1.006 6-18 Parameter Function P1.006 Speed command smoothing constant (low-pass filter)