Motion Control ASDA-B3 (1 ms command cycle) (1 ms command cycle) External interruption PR#1 PR#2 DLY=[1] 100 ms Speed DLY=[0] 0 ms Speed 7 PR executor 100 rpm Acc=[11] 100 ms Dec=[11] 100 ms 500 rpm Acc=[11] 33.3 ms Dec=[11] 33.3 ms (1 ms command cycle) (1 ms command cycle) PR#11 Speed 500 rpm Acc=[0] 33.3 ms Dec=[0] 33.3 ms DLY=[0] 0 ms 500 Motion command generator 200 100 (b) External interruption - Speed command Time Figure 7.1.6.10 External interruption Overlap command If the previous position command includes an Overlap function, it allows the next command to be executed while the previous motion is decelerating, thus achieving a continuous motion.
When you use an Overlap command, the delay time is still effective. The delay time starts to count from the command’s start point; however, in order to have the commands transition smoothly, setting the delay time of the previous command to 0 is suggested. In addition, if deceleration time of the previous command is identical to acceleration time of the next, the transition between commands can be very smooth, avoiding discontinuous speed during transition (see Figure 7.1.6.11). The calculation is as follows.
1st target speed (𝑆𝑝𝑑1) 3000 Ч Deceleration time (𝐷𝑒𝑐) = 2nd target speed (𝑆𝑝𝑑2) 3000 Ч Acceleration time (𝐴𝑐𝑐) An Interrupt command has a higher priority than an Overlap command. Thus, when you set an Overlap function in the current Position command, and the next motion command includes an Interrupt function, only the command with the Interrupt function is executed. 7-56 PR# 10 (I) Sp eed DLY=[ 200 Acc=[12 Dec=[12 0] 0 ms rpm ] 333 ms ] 333 ms (rpm)