Parameters ASDA-B3 8 Note: pin definition of the communication type models is different from that of the L model. Communication type model pins: SIGN (23), /SIGN (24), PULSE (25), and /PULSE (26). UY: filter width setting If the pulse frequency is too high, causing a pulse width smaller than the filter width, then this pulse gets filtered out as noise. Therefore, set the filter width smaller than the actual pulse width. You should set the filter width as 4 times smaller than the actual pulse width.
8-30 Logic Pulse Pulse input type type Forward Reverse Sign = low Sign = high (43) PULSE TH (41) T4 T5 T6 T5 T6 T5 T4 (39) SIGN (37) (43) PULSE TH (41) T4 T5 T6 T5 T6 T5 T4 (39) SIGN (37) Z = 0 X = 2 T5 T4 T4 T5 T6 T6 T5 T5 T5 T5 T4 T6 T4 T6 Pulse specification Maximum input frequency Minimum allowed time width T1 T2 T3 T4 T5 T6 Differential signal 4 Mpps 62.5 ns 125 ns 250 ns 200 ns 125 ns 125 ns Open-collector 200 Kpps 1.25 μs 2.5 μs 5 μs 5 μs 2.5 μs 2.5 μs Pulse specification Maximum input frequency Voltage Forward current Differential signal 4 Mpps 5V Open-collector 200 Kpps 24V (maximum) U = 0 U = 1 Y Unit: μs (kHz) Unit:
μs (kHz) 0 No filter function No filter function 1 2 (250) 0.2 (2500) 2 3 (166) 0.3 (1666) 3 4 (125) 0.4 (1250) 4 5 (100) 0.5 (1000) 5 6 (83) 0.6 (833) 6 7 (71) 0.7 (714) 7 8 (62) 0.8 (625) 8 9 (55) 0.9 (555) 9 10 (50) 1 (500) A 11 (45) 1.1 (454) B 12 (41) 1.2 (416) C 13 (38) 1.3 (384) D 14 (35) 1.4 (357) E 15 (33) 1.5 (333)