Delta Electronics — P1.xxx Basic parameters

ASDA-B3 Parameters P1.034: set the acceleration time for the trapezoid-curve. P1.035: set the deceleration time for the trapezoid-curve. P1.036: set the smoothing time for the S-curve acceleration and deceleration. 8 You can set P1.034, P1.035, and P1.036 individually. Even if you set P1.036 to 0, the acceleration and deceleration still follow a trapezoid-curve. Note the following error compensation: Settings: Load inertia ratio of servo motor (rotary motor): (J_load / J_motor) J_motor: moment of inertia of the servo motor J_load: total equivalent moment of inertia of external mechanical load Settings: Sets the range for the zero-speed signal (ZSPD).

When the forward or reverse speed of the motor is slower than this value, the zero-speed signal is triggered and DO.ZSPD is on. 8-45 P1.036 = 0 P1.036 = 1 P1.036 > 1 Smoothing function for S-curve Disabled Disabled Enable Following error compensation function Disabled Enable Determined by P2.068.X Address: 014AH P1.037 Load inertia ratio 014BH Operation Panel / software Communication All Control mode: interface: 6.0 0.0 (B3-F) 60 0 (B3-F) 16-bit Default: Data size: Unit: 1 times 0.1 times - - Setting range: 0.0 - 200.0 0 - 2000 - - Format: One decimal DEC - - Example: 1.5 = 1.5 times 15 = 1.5 times - - Address:

014CH 014DH P1.038 Zero speed range Operation Panel / software Communication All Control mode: interface: Default: 10.0 100 Data size: 16-bit Unit: 1 rpm 0.1 rpm - - Setting range: 0.0 - 200.0 0 - 2000 - - Format: One decimal DEC - - Example: 1.5 = 1.5 rpm 15 = 1.5 rpm - -