Parameters ASDA-B3 X: DO output hold option 0: output status is not retained 8 1: output status is retained Y: position deviation alarm (AL380) option 0: AL380 not functioning 1: AL380 functioning Diagram: 1. Position command triggered 3. Command output 2. DO.Cmd_OK 4. DO.TPOS 5. DO.MC_OK 6. DO.MC_OK after first time on 8. AL380 triggered Description: 1. Command triggered: new PR command is effective. Command 3 starts and clears signals 2, 4, 5, and 6 simultaneously. Command triggering source: DI.CTRG, DI.EV1/EV2, and P5.007 (triggered through software). 2. DO.Cmd_OK: indicates whether command 3 is complete, and can be set with a delay time (DLY) with parameters. 3. Command output:
output the profile of the Position command based on the setting for acceleration or deceleration. 4. DO.TPOS: indicates whether position error of the servo drive is within the range set in P1.054. 5. DO.MC_OK: Position command output and servo positioning completed, which indicates that DO.Cmd_OK and DO.TPOS are both on. 6. DO.MC_OK (retains digital output status): same as 5, except that once this DO is on, its status is retained regardless of the signal 4 status. 7. Can only select either signal 5 or signal 6 to output, and the choice is specified in P1.048.X. 8. Position deviation:
when event 7 occurs, if signal 4 (or 5) is off, it means the position has deviated and AL380 can be triggered. Use P1.048.Y to set whether AL380 is functioning. 8-50 DLY tput P1.048.X = 0: output not retained P1.048.X = 1: output retained P1.048.Y = 7