ASDA-B3 Parameters 8 Settings: Y Z U X Reserved Reserved X: setting for position command issued by the analog signal 0: disable 1: enable Y: initial position setting 0: after the servo is on, the motor regards the current position as the position when the voltage is 0V. Then the motor will operate to the position according to the command issued by analog input. Motor position (Turn) The motor operates to the position corresponding to the current voltage command when this function is executed The current position is regarded as the position Analog input command (V) Current command level when the voltage is 0V 1:
after the servo is on, if the command level is not changed, the motor does not operate. The position the motor stops at is the position corresponding to the current command level. Motor position (Turn) Motor current The motor does not operate if the position command level is not changed when this function is executed The position corresponding Analog input command (V) Command level to 0V is not changed 8-55 Address: 0180H P1.064 Analog position command: activation control 0181H Default: 0x0000 Control mode: Unit: - Setting range: Format: HEX Data size: X Setting for position command issued by the analog signal Z Y Initial position setting U