Parameters ASDA-B3 8 Y: gain switching method 0: gain rate switching 1: integrator switching (switch from P controller to PI controller) Settings: Controls the switching of smoothing gain. Settings: You determine the gain switching (pulse error, kpps, rpm) by the selection of gain switching condition (P2.027).
8-72 X Function 2 In position control mode, position error is larger than P2.029 3 Frequency of Position command is larger than P2.029 4 Rotation speed of servo motor is faster than P2.029 5 Signal of gain switching (DI.GAINUP) is off 6 In position control mode, position error is smaller than P2.029 7 Frequency of Position command is smaller than P2.029 8 Rotation speed of servo motor is slower than P2.029 Setting Control mode P Control mode S Gain switching value 0 P2.000 x 100% P2.004 x 100% P2.004 x 100% Before switching P2.000 x P2.001 P2.004 x P2.005 P2.004 x P2.005 After switching 1 P2.006 x 0%; P2.026 x 0% Before switching P2.006 x 100%; P2.026 x 100% After switching Address:
0238H P2.028 Gain switching time constant 0239H Default: 10 Control mode: All Unit: ms Setting range: 0 - 1000 (0: disable this function) Format: DEC Data size: 16-bit Address: 023AH P2.029 Gain switching condition 023BH Default: 16777216 Control mode: All Unit: pulse; kpps; rpm Setting range: 0 - 50331648 Format: DEC Data size: 32-bit