ASDA-B3 Parameters 8 Settings: Note: set the value to 0 during normal operation. The value returns to 0 automatically after power cycling. Settings: In gain adjustment mode (P2.032), adjust the servo bandwidth with the bandwidth response level parameter (P2.031). When you increase the bandwidth response level (P2.031), the servo bandwidth increases as well. Refer to Chapter 5 for adjustment details. 8-73 Address: 023CH P2.030■ Auxiliary function 023DH Default: 0 Control mode: Unit: - Setting range: Format: DEC Data size: Setting Function value 0 Disable all functions described as follows. 1 Switch servo to Servo On state. 2 to 4 Reserved. 5 This setting makes all parameter settings volatile.
When there is no need to save the data, this setting can avoid continually writing the parameters to EEPROM and shortening the lifetime of the EEPROM. You must use this function when controlling through communication. 6 This setting enables command simulation mode. In this mode, use the DI/O in ASDA-Soft to Servo On as both the external Servo On signal and the force Servo On of the PR mode in ASDA-Soft cannot work. Also, the DSP Error (variable 0x6F) is read as 0 and P0.001 only shows the external error code (positive / negative limit, emergency stop).
In this mode, DO.SRDY is on, commands are accepted in each mode and can be observed through the scope function of the software, but the motor does not operate. Use this mode to examine command accuracy. 7 Reserved. 8 Back up all current parameter values to EEPROM, so that the values are retained after power cycling. The panel displays ‘to.rom’ during execution. This feature can also be executed when servo is in the Servo On state. -1, -5, -6 Disable the functions of 1, 5, and 6. -2 to -4, -7, -8 Reserved. Address: 023EH P2.031 Bandwidth response level 023FH Default: 19 Control mode: All Unit: - Setting range: 1 - 50 Format: DEC Data size: 16-bit