Delta Electronics — P2.xxx Extension parameters

ASDA-B3 Parameters 2: auto resonance suppression mode 2; when the servo determines it is stable* 2 , the servo stores the resonance suppression points to EEPROM (non-volatile memory for parameters). In this mode, the searching cycle continues until the 5 sets of resonance suppression parameters are 8 set, then the auto resonance suppression function is disabled (X = 0). Before the servo is stable, (1) If you cycle power on the servo drive, the resonance suppression points that are not yet stored to EEPROM are lost and will not be saved. The resonance suppression points that have been stored to EEPROM are not affected.

(2) If you switch the setting of X from 2 to 0, the known resonance suppression points will be stored to EEPROM. (3) If you keep the setting of X as 2, the known resonance suppression points will not be cleared, but they are not written to EEPROM yet. They are written to EEPROM when the servo determines it is stable. Note: 1. If you switch the setting of X from 0 to 1 or 2, the system clears the unfixed Notch filter, and sets the 2. The servo determines it is stable when the following conditions are met: resonances have been frequency to 1,000 Hz and the suppression level to 0 dB.

suppressed, no other interference that affects the operation is found, and the motor speed is maintained at above 10 rpm for 3 minutes.  Y: fixed resonance suppression parameter In auto resonance suppression mode, set the Notch filters to use manual resonance suppression. Bit  Z: fixed resonance suppression parameter In auto resonance suppression mode, set the Notch filters to use manual resonance suppression. Bit Example: if P2.047 = 0x0021, and the auto resonance suppression function is enabled, the servo searches for the resonance point and suppresses it. When you set Y [Bit 1] to 1, you manually set the second set of resonance suppression parameters.

Then, if the servo finds 2 resonance points, 8-79 3 2 1 0 Bit Function Description Bit 0 Notch 1 auto / manual setting 0: auto resonance suppression 1: manually set the first set of resonance suppression parameters Bit 1 Notch 2 auto / manual setting 0: auto resonance suppression 1: manually set the second set of resonance suppression parameters Bit 2 Notch 3 auto / manual setting 0: auto resonance suppression 1: manually set the third set of resonance suppression parameters Bit 3 Notch 4 auto / manual setting 0: auto resonance suppression 1: manually set the fourth set of resonance suppression parameters 3 2 1 0 Bit Function Description Bit 0 Notch 5 auto / manual setting 0:

auto resonance suppression 1: manually set the fifth set of resonance suppression parameters