Delta Electronics — P2.xxx Extension parameters

Parameters ASDA-B3 it writes the data of the 1 st point to the 1 st set of resonance suppression parameters and the data of the 2 nd point to the 3 rd set of resonance suppression parameters. That is, it skips the 2 nd set of 8 parameters. Settings: The smaller this parameter value, the more sensitive it is to resonance. The larger this parameter value, the less sensitive it is to resonance. Settings: Sets the filter for speed estimation. Adjusting this parameter can improve the extent of the speed jitter, but when the value is too high, the phase margin affecting the speed loop decreases, and thus makes the system unstable. Refer to Table 8.1 for digital input descriptions.

Set digital input (DI) as CCLR to enable the Pulse Clear Settings: function. If this DI is on, the accumulated position error is reset to 0. When P2.050 = 0: DI.CCLR is rising-edge triggered. When P2.050 = 1: DI.CCLR is level triggered. 8-80 Address: 0260H P2.048 Auto resonance detection level 0261H Default: 100 Control mode: All Unit: - Setting range: 0 - 1000 Format: DEC Data size: 16-bit Address: 0262H P2.049 Speed detection filter and jitter suppression 0263H Operation Panel / software Communication All Control mode: interface: Default: 1.0 10 Data size: 16-bit Unit: 1 ms 0.1 ms - - Setting range: 0.0 - 100.0 0 - 1000 - - Format: One decimal DEC - - Example:

1.5 = 1.5 ms 15 = 1.5 ms - - Address: 0264H P2.050 Pulse Clear mode 0265H Default: 0x0000 Control mode: PT Unit: - Setting range: 0x0000 - 0x0001 Format: HEX Data size: 16-bit P 2.051 Reserved