Troubleshooting ASDA-B3 12 12-26 AL06A Absolute position is lost Trigger condition and cause 3. The absolute encoder of this motor is in error. 4. If J1 and J2 are connected reversely, the battery cannot charge the capacitor. The function of the capacitor is to act as a buffer to supply power when the power of the servo drive is cut off and switching to battery power supply. Checking method and corrective action 1. Check if the absolute origin coordinates are established (refer to Section 10.3.1 for more information). 2. Avoid replacing the battery when the servo drive is powered off.
It is suggested to replace the battery when the servo drive is powered on, so the absolute encoder has continuous power supply. 3. Re-execute homing to complete establishing the absolute coordinate system. 4. Replace the encoder cable. Use the X-ray to check if the internal wiring is damaged. 5. Check if the connector is loose and the machine vibrates excessively. If both are fine, then replace the battery box for cross-testing. 6. Replace the servo motor. 7. Ensure that J1 is connected to the battery and J2 is connected to the servo drive. How to clear the alarm? This alarm is automatically cleared after you establish the absolute origin coordinates.
AL070 Encoder did not complete the set-up command issued by servo drive Trigger condition and cause Reading and writing commands are not complete. Checking method and corrective action Check if the wiring is correct and the connector is firmly connected. Correctly connect the wiring. Contact Delta if this error persists. How to clear the alarm? Cycle power on the servo drive. AL072 Encoder overspeed Trigger condition and cause When the encoder is powered by the servo drive: over 8,800 rpm. When the encoder is powered by the battery: over 10,000 rpm. Checking method and corrective action 1. Check if the motor is properly grounded.
Make sure the power cable is grounded to the servo drive heat sink. 2. Make sure the encoder signal cable is separated from the power supply or any high-current cables to avoid interference.