Badlands Universal Kit Installation Table 1- 3 JAMMA a Component Side ‘Signal Note" oe Wire Connections Solder Side Wire 2 Color _ WEN | 4b BN AV RIN. +5V . t5V SV tIZV0 a COIN CTR 1 Notused. SPKR+ to 5 BUAW. V/W sos TR, 17 BN_ AUDIO+ coe RED... 6 BLUE o : R GN = 6 BU BN VIDEO GND 6 BK GY SELF-TEST 7 Ww 8 —BK/Y Left Player COIN1 © FIRE/START1 Spare Spare Spare 10 oS . . 6 COMPSYNC Not used | oe Not used Right Player BK/OR © W/BK Y/BK W/BN W/R W/OR Y/BN Y/R Y/OR | 9 a COIN2) 10. FIRE/START 2 Spare Spare Spare. Spare WY YI FIRE/START. 1.10 PEDAL 1 I5 W/GN W/BU Y/GN Y/BU li. 15. FIRE/START 2 PEDAL2.. PEDAL 1 16 W/V Y/Y. 16 PEDAL 2 STEERING GND C13 14 Vv BK/W GY/W BK/W 13...
STEERING C 144 GND 14 BK/W STEERINGD GND 12 W/GY Y/GY BK/W * Notes for this table are on page 1-7. — Spare 12. a STEERINGD _ 14 GND _ Installing and Connecting the Harness WARNING Do not simply tie the wires together. If you CAUTION do, you could cause intermittent problems, loose connections, oxidation, or a fire. To meet FCC requirements, install the split beads included in the kit over all the wires in the harness as close to the connector as possible. 1. If your game does not already have a JAMMA ness, find the JAMMA har- harness (part no. A046501- 01) in the kit and install it.
Using Table 1-3, JAMMA Pin and Wire Connections, for wiring information, connect the JAMMA harness to existing component Use crimp splices or butt soldering. harnessing. Connecting Power Wires 1. Connect the wires on the JAMMA harness to the wires for the power supply, as shown in Table 1-3. The Badlands kit requires +5V and +12V. If -5V is available, it should be used too. If -5V is not available, connect both wires to the 5 V RTN (GND) terminal on the power supply unless the power supply has 12V RTN. If it does, connect both wires to it.