EuroV MBE 900 Operators Manual 4. Using the same procedure, check the valves in the "Valve Overlap" row and adjust them (if necessary), using the procedures under the headings "Checking Valve Lash" and "Adjusting Valve Lash." Table 11. 14.4.3 Checking Valve Lash Check valve lash as follows: 1. For each valve, measure the valve lash with a feeler gauge between the rocker arm and valve stem (exhaust valve) or valve bridge (intake valve). It should be possible to pull the feeler gauge through with no more than light resistance. 2. If the value measured is within the range listed in Table "Valve Lash Checking and Adjustment" in the "Check For" column, check the next valve. 3.
If the value measured is within the range listed in Table "Valve Lash Checking and Adjustment" in the "Check For" column, check the next valve. 14.4.4 Adjusting Valve Lash Adjust valve lash as follows: 1. If adjustment is needed, loosen the locknut. See figure below for intake valves and exhaust valves. Use the exact settings listed in "Valve Lash Checking and Adjustment" table in the "Adjust To" column. All information subject to change without notice.
33 DDC-SVC-MAN-0207 Copyright © 2019 DETROIT DIESEL CORPORATION Valve Adjustment- Method Two Engine Cylinder #1 Crankshaft Position Cylinders/Valve Types 1 2 3 4 5 6 4-cylinder Ignition TDC Intake/ Exhaust Intake Exhaust -- NA NA Valve Overlap -- Exhaust Intake Intake/ Exhaust NA NA 6-cylinder Ignition TDC Intake/ Exhaust Intake Exhaust Intake Exhaust -- Valve Overlap -- Exhaust Intake Exhaust Intake Intake/ Exhaust