MAN — 14.5 Fuel Prefilter Element Cleaning

14 Maintenance Figure 2. Intake Valves Figure 3. Exhaust Valves Table 12. 2. Turn the adjusting screw until the valve lash is correct using the exact settings listed in "Valve Lash Checking and Adjustment" table, above. Use the range only for checking adjustment. 3. Tighten the locknut 25 N·m (18 lb·ft ). 4. Check the valve lash again. Adjust again if necessary. 14.4.5 Restoring The Vehicle To Operating Condition Restore to operating condition as follows: 1. Install the cylinder head cover. Refer to section "Removal of the Cylinder Head Cover". 2. Remove the cranking device from the inspection hole in the timing case. 3.

Replace the end cover on the inspection hole and tighten the bolts 25 N·m (18 lb·ft). 34 All information subject to change without notice. Copyright © 2019 DETROIT DIESEL CORPORATION DDC-SVC-MAN-0207 Valve Lash Checking and Adjustment Valve Type Check For: Adjust to: Intake 0.30 to 0.60 mm (0.012 to 0.024 in.) 40 mm (0.016 in.) Exhaust 0.50 to 0.80 mm (0.020 to 0.032 in.) 60 mm (0.024 in.)