EuroV MBE 900 Operators Manual Figure 13. Oil Centrifuge 2. Lift out the dirty cartridge and replace it with a clean one. Figure 14. Centrifuge Cartdirge 3. Replace the centrifuge cover, tighten the cap 40 Nm (30 lb·ft). 14.8 Coolant Concentration Checking Check coolant concentration as follows: WARNING: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. Open the cap on the surge tank slowly, to allow excess pressure to escape. Set the cap aside. NOTE:
Check and correct the coolant level only when the coolant temperature is below 50°C (122°F). NOTE: Concentrations of more than 55% by volume should not be used, as this is the level which affords the maximum antifreeze protection, down to -45°C (-49°F). Higher concentrations adversely affect heat dissipation. 2. Before adding coolant, use a suitable tester to check the concentration of corrosion-inhibiting antifreeze. If the concentration is lower than 50% by volume, drain coolant/add antifreeze until the concentration is correct. The coolant mixing ratio is listed in the "Coolant Mixing Ratio" table. All information subject to change without notice.
41 DDC-SVC-MAN-0207 Copyright © 2019 DETROIT DIESEL CORPORATION