Test Control unit Flashcode: 1x long, 6x short Fault indication: Fault is indicated by the EDC indicator lamp coming on continuously Fault path: Control unit fault (processor coupling) Effect of fault: Engine is shut down by “no power applied to fuel delivery output stage” and control position set to 0 If this fault occurs only temporarily, the engine can be restarted after switching the “ignition” off and on again Possible cause: Undervoltage (loose contact), control unit fault Test precondition:
EDC control unit connected 41 Test Measurement Corrective measures The controller contains This fault signal can also occur in the event of extremely low power supply (loose contacts or undervoltage) Internal fault in control unit – Check lines – Check plug connections – Replace control unit (only dis- connect the control unit once the current is switched off)