John Deere 230LCR, 230LCRD — CHAPTER 7

TM 5-3805-280-10 Operating the Machine BUCKET DIGGING: For power digging and for working in a small or cramped excavation. Use the bucket cylinder (A) for digging. Lower bucket to the digging area and use boom to force the bucket into the ground. Work two functions at once; retracting the arm, and curling the bucket until the bucket is full. If the bucket stalls, raise the boom slightly and continue to curl bucket. If arm stalls, roll back bucket to break out. IMPORTANT: To avoid damaging cylinder(s), do not strike ground with bucket or use bucket for tamping when bucket cylinder is fully extended (bucket completely curled under).

When bucket cylinder is fully extended, do not strike the ground with the bucket or use the bucket for tamping. T7527CW –UN–10JUL91 Do not use the bucket as a hammer or pile driver. Do not attempt to shift rocks and break walls using swing motion. Do not sideload bucket. For example, do not swing bucket to level material or do not strike objects from the side with the bucket. Match bucket, bucket teeth, or attachment to type of material being handled. Loose, fragmented material dumps quickly from the bucket. To break up material as it enters the bucket, excavate material in thin layers rather than jamming it into the bucket. This is especially important with sticky materials.

If you clean the bucket by rapping it against the stop, to prevent cylinder damage, use the MINIMUM amount of force. Clean the bucket by hand if rapping bucket lightly does not work. Do not try to remove material from bucket by striking bucket against the ground or another object. Continued on next page TX,35,FF2325 –19–28JAN92–2/3 7-24