TM 5-3805-280-10 Maintenance—Every 1000 Hours CLEAN THE ENGINE CRANKCASE VENTILATION TUBE Clean the engine crankcase ventilation tube (A) when you measure and adjust engine valve clearance (lash). T108260D –UN–27MAR97 TX,85,DH5580 –19–10AUG96–1/1 CHECK AND ADJUST ENGINE VALVE LASH (CLEARANCE) CAUTION: Prevent accidental starting of engine while performing valve adjustments. Always disconnect NEGATIVE (-) battery terminal. RG7408 –UN–06AUG96 IMPORTANT: Valve clearance MUST BE checked and adjusted with engine COLD. 1. Remove rocker arm cover and engine crankcase ventilation tube. Clean tube with solvent or diesel fuel. Check that O-ring in rocker arm cover is in good condition. IMPORTANT:
Visually inspect contact surfaces of valve tips and rocker arm wear pads. Check all parts for excessive wear, breakage, or cracks. Replace parts that show visible damage. Rocker arms that exhibit excessive valve clearance should be inspected more thoroughly to identify damaged parts. 2. Remove plug (A). Install JDG820 Flywheel Turning Tool. Remove cap screw (B). Install JDE-81-4 Timing Pin. Continued on next page TX,86,DH5104 –19–09JUL96–1/2 16-3