TM 5-3805-280-10 OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES FOR HYDRAULIC EXCAVATOR 230LCR/230LCRD A-4 ITEM NO. INTERVAL ITEM TO BE INSPECTED PROCEDURE: DO THE PMCS AND HAVE ITEM REPAIRED, FILLED, OR ADJUSTED AS NEEDED EQUIPMENT IS NOT READY/AVAILABLE IF: 1 2 3 4 5 6 7 8 Before Before Before Before Before Before Before Before Check Fuel Tank (Fill at End of Day) NOTE: Items 2 through 4 are applicable to Model 230LCR only. Grease All Material Clamp Joints (1) Pump grease into the four indicated grease points (see Fuels and Lubricants, Chapter 9).
Check for Loose or Missing Material Clamp Bolts and Nuts Inspect Material Clamp for Damage or Weld Cracks Clean Dirt and Debris from Quick-Disconnect Hitch Attachment Front Hooks and Rear Saddles Inspect for Damage and Clean Dirt and Debris from Overload Alarm Proximity Sensor NOTE: Items 7 through 16 are applicable to Model 230LCRD only. Check CPA Attachment of Rock Drill to Hitch Adapter (1) Ensure that all fixing pins are secure. Inspect Guide Chains and Ropes of the Rock Drill (1) Inspect the front chain for wear. (2) Inspect hose reel rope. Specifically inspect attachment points on tightener and chain.
Fittings damaged or missing Any damage that will prevent operation Damage or weld cracks are present Damaged sensor Fixing pins are loose or missing 2 broken wires within 36 (1.44 in.) (6 times nomin diameter of cable) OR