John Deere 230LCR, 230LCRD — APPENDIX A

TM 5-3805-280-10 OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES FOR HYDRAULIC EXCAVATOR 230LCR/230LCRD A-5 ITEM NO. INTERVAL ITEM TO BE INSPECTED PROCEDURE: DO THE PMCS AND HAVE ITEM REPAIRED, FILLED, OR ADJUSTED AS NEEDED EQUIPMENT IS NOT READY/AVAILABLE IF: 9 10 11 Before Before Before Check rope for flats on outside strands, crushing, swelling, or fraying. If rope requires replacement, notify your supervisor. (3) Move drifter at slow speed to front end position. (4) Check chain reel for wear or corrosion. If reel requires replacement, notify your supervisor. Check Oil Level of Pressurization Air Oiler of Rock Drill (1) Remove oil fill plug (1). (2) Check oil level.

Add oil if necessary (see Fuels and Lubricants, Chapter 9). Lubricate Hydraulic Drifter Front End Head of Rock Drill (1) Lubricate the hydraulic drifter front part with 5 or 6 shots of hand pump grease (see Fuels and Lubricants, Chapter 9). Check Compressor Oil Level (1) Open compressor left side access door. 4 broken wires within 18 (7.2 in.) (30 times nomin diameter of cable) OR Cable diameter is less th 5.4 mm (0.21 in.) (nomin diameter) No oil visible or low level