TM 5-3805-280-10 OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES FOR HYDRAULIC EXCAVATOR 230LCR/230LCRD A-6 ITEM NO. INTERVAL ITEM TO BE INSPECTED PROCEDURE: DO THE PMCS AND HAVE ITEM REPAIRED, FILLED, OR ADJUSTED AS NEEDED EQUIPMENT IS NOT READY/AVAILABLE IF: 12 13 Before Before (2) Start unit (refer to air compressor operating instructions). Allow unit to warm up. (3) With compressor running at full load, check sight tube located on the side of the receiver tank. The optimum operating level is midway of the sight tube. Oil level should be within the “OK” range. (4) If oil level is not within the “OK” range, add oil to receiver tank (see Fuels and Lubricants, Chapter 9). NOTE:
Ensure that access door is closed securely after inspection is complete. Check Compressor Engine Oil Level (1) Open compressor rear right access door. (2) Make sure dipstick is fully seated. (3) Remove dipstick and check oil level. (4) Add oil if level is below ADD mark (see Fuels and Lubricants, Chapter 9). NOTE: Ensure that access door is closed securely after inspection is complete. Check Compressor Gauges/Lamps (1) Open compressor rear left access door. (2) On control panel, set switches SW1 and SW2 to OFF, then to ON. Panel lights PL1 and PL2 should go on. All diagnostics lamps will light (glow) for approximately 2 seconds.
Then all lamps should go off except for LOW ENGINE OIL PRESSURE. (3) Check and replace any lamp that fails to light. (4) Set switches SW1 and SW2 to OFF. Oil level not within “OK” range Oil level is below ADD mark on dipstick Any light fails to function