John Deere 230LCR, 230LCRD — APPENDIX A

TM 5-3805-280-10 OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES FOR HYDRAULIC EXCAVATOR 230LCR/230LCRD A-8 ITEM NO. INTERVAL ITEM TO BE INSPECTED PROCEDURE: DO THE PMCS AND HAVE ITEM REPAIRED, FILLED, OR ADJUSTED AS NEEDED EQUIPMENT IS NOT READY/AVAILABLE IF: 20 Before (1) Open right-side access door. (2) Look for evidence of hydraulic leaks. NOTE: Note the Arm, Boom, and Bucket position on the placard located to the left of the hydraulic sight gauge. This information will be used with the hydraulic oil level check to be performed later. (3) Check oil level window (A) on hydraulic tank. Oil must be visible in sight gauge within safe operating range as indicated on sight gauge.

(4) If empty or low, add oil (see Check Hydraulic Oil Level under During - Start and After-Start Checks). Check Pump Drive Gearbox Oil Level (1) Pull dipstick (A) from tube and check oil level. (2) Add oil if below “H” mark (see Monthly - Check Pump Drive Gearbox Oil Level). NOTE: Ensure that access door is closed securely after inspection is complete. Any Class III leak eviden No hydraulic oil visible or not within safe operating range No oil in pump gearbox or below the ADD or SAFE mark on the dipsti